Flowdur PAS Clear is a clear, fast curing, two-component solvent free polyaspartic floor coating for concrete surfaces. Flowdur PAS provides a UV-resistant, tough, hard wearing coating system and can be used to produce decorative flake systems in conjunction with Flowdur PAS Coloured.
Flowdur PAS Clear may be applied between 10 °C and 30 °C. However, for best results, substrate and air temperature should be in the range 15 °C to 25 °C otherwise workability and cure rate may be impaired.
Coloured gloss finish.
Decorative applications, warehouses, laboratories and food preparation areas.
Features & Benefits
- Fast cure. Ultra-quick return-to-service
- 100% solids. VOC free
- Excellent UV resistance
- Low viscosity
- Gloss, easy to clean finish
- Extremely durable & impermeable finish
150 - 250 microns per coat depending on specification.
Typical Properties, 28 days at 20 ºC
BS 8204-6 Type 3
Bond strength (BS EN 13892-8) > 3.0 N/mm2 (concrete failure)
Impact resistance (BS EN ISO 6272-1) 4.7 Nm
Wear resistance (BS EN 13892-5) < 50 μm
The typical physical properties given above are derived from testing in a controlled laboratory environment. Results derived from testing field-applied samples may vary dependent upon site conditions.
2.5 kg and 5 kg units.
Cure Schedule @ 20 °C *
Over coating time 90 minutes ~ 12 hours
Cure time to pedestrian traffic ~ 4 hours
Cure time to light wheeled traffic ~ 8 hours
Full cure ~ 5 days
Please see Technical Data Sheet for further information.
Flowdur PAS Clear Technical Data Sheet