Loading... Please wait...
  • Epoxy Damp Proof Membrane

Customers also viewed

Flowprime Damp Proof Membrane

£104.40 (inc VAT) £87.00 (exc VAT)
Quantity:
Weight:
5.00 KGS
Shipping:
Calculated at checkout

Product Description

Description

Flowprime DPM is a two-component solvent-free liquid applied surface damp proof membrane and residual moisture suppressant. After curing, Flowprime DPM provides a surface membrane with excellent adhesion to damp concrete and polymer modified sand/cement screeds. Hygrometer readings up to 98% RH as measured in accordance with BS 8203:2001 can be accommodated. Flowprime DPM is available in red and yellow as a visual aid for application and coverage.

Uses

Flowprime DPM has been designed for use as a coating over cementitious surfaces which posses high levels of residual moisture or where an integral DPM is not present or not effective. This practice should only be adopted subject to a survey confirming adequate underlying ground stability. Moisture testing should be carried out in accordance with BS 8203.

Flowprime DPM permits early overlaying with vinyl, carpets and resin based products without the conventional “drying out” period being observed. This product is not suitable for use over under-floor heating systems.

Thickness

450 microns (two coat system)

Technical Data

pdf-icon1.png

Application Advice

Mixing:
Fully drain the contents of the hardener component into the lightly coloured resin component and mix thoroughly with a slow speed electric stirrer fitted with a spiral paddle, for a minimum of 3 minutes until homogeneous.
Application:
Apply evenly using a notched trowel (1.5 mm x 5 mm V shaped) and flatten out the ridges with a pre-wetted-out short pile roller whilst still wet. Do not exceed the coverage rate of 4 m2 /kg under any circumstances. It is essential that each coat
Coverage Rate:
4 m2 /kg/coat at 225 microns/per coat. A minimum of two coats are required. Coverage will be reduced by rough, porous substrates and more material may be required to achieve the minimum wet film thickness requirements.
Curing Schedule at 20ºC:
Working life of full packs is 30 minutes. Minimum time to overcoat is 12 hours. Maximum time to overcoat is 48 hours.

Product Reviews

Write Review

  1. usage

    Posted by Unknown on 14th Sep 2015

    adhered to the original floor well, good coverage.