The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

Flowprime SF - Low Viscosity Epoxy Primer

£93.60
(Inc. VAT)
£78.00
(Ex. VAT)
(No reviews yet) Write a Review
Weight:
5.00 KGS
Shipping:
Calculated at Checkout
Bulk Pricing:
Buy in bulk and save
Mixing:
Add the hardener component to the resin component and mix using a low speed electric mixer (200 - 500 rpm) fitted with a mixing paddle designed to minimize air entrainment for 1 - 2 minutes until homogeneous.
Application:
Work the primer into the surface using a stiff brush or roller avoiding pooling. On porous surfaces Pumaprime SF will be absorbed very quickly leaving dry patches. A second coat should be applied to these dry areas to ensure good adhesion and red
Coverage Rates:
Coverage varies widely due to the porosity and profile of different substrates. As a guide: Rough porous concrete - 175g/m² Average finish - 125g/m² Smooth finish - 100g/m²
Curing Schedule at 20ºC:
Working life of full packs is 25 minutes. Over coating time is 15 - 36 hours.

Flowprime SF is a two-component low-viscosity epoxy primer with good penetrating properties for use on concrete and polymer modified cementitious screeds. Flowprime SF is designed to improve the adhesion of floor toppings and mortars to the substrate.

Features & Benefits

  • Low viscosity - penetrates the substrate
  • Seals concrete pores - reduces the potential for out gassing and pin holing in resin floor finishes
  • Improves the adhesion of toppings to the substrate
  • Easy to mix and apply

Suitable Substrates

Thoroughly prepared concrete, polymer modified sand and cement screeds, steel, brickwork, block work and timber.

Technical Data

Flowprime SF Technical Data Sheet

pdf-icon1.png