Strongcoat is a two pack, solvent free, very hard wearing, epoxy floor paint for use in heavy duty areas where a hard wearing and chemical resistant surface is required.
A smooth gloss finish in a range of attractive colours. Can have a textured finish with the addition of Anti-slip Aggregate.
- Fast Cure (faster drying times)
- Skydrol-resistant (ideal for aviation hangars where fuel leaks are likely to happen).
- Processing and manufacturing plants.
- Frequent fork lift truck traffic areas
- Factories and warehousing
- Food preparation, food storage areas and breweries.
- Commercial garages, vehicle repair and maintenance depots, aircraft hangers
- Chemical plant storage areas.
- Car Parks
- Even on rough and uneven floors, it will cure to give a smooth, easy to clean surface.
- Excellent chemical resistance.
- Hygienic, seamless floor finish.
- Low odour
- Solvent free
- Will not support bacterial growth.
Can be made decorative with the addition of Virtus PVA Flakes scattered into the wet resin, once dry, sand down any protruding or Flake edges and seal with Strongcoat Clear. Can be made anti-slip with the addition of Virtus Anti -Slip Aggregate scattered into the first coat of wet resin.
Concrete, metal, polymer modified cementitious screeds.
Usage: Indoor (some colour change would occur if used outdoors)
Resistant to: A wide range of acids and other chemicals.
Coverage: 20 square metres per 5kg
Coats Required: Two coats are usually required
Time In-between Coats : 16-36 hours between coats
Drying Time: Normally 8 - 24 hours at 20oc for foot traffic and 48 hours for vehicular traffic.
Pack Sizes: 5kg, 10kg or 15kg comprising a tin of resin and a tin of hardener.
Cleaning: Hot water jet washing, detergents and mechanical scrubber dryers.
Thickness: Approx 0.5 mm (from 2 coats). Can be built up to a maximum of 1 mm thickness from the application of multiple coats.
Primer: A primer is not normally required. However, on weak or porous concrete it is advisable to prime with Flowprime SF. For floors suffering from oil contamination, where oil has penetrated the slab, it is available to prime with Flowprime OCS. For floors where there is no damp proof membrane in the construction of the floor or if the concrete is new and has not had time to dry out thoroughly, it is advisable to use Flowprime DPM.
Surface Preparation: Surfaces to be treated must be clean, sound, free from oil or other contaminants, flaky paints, laitance and dust. Smooth and dense surfaces must be mechanically abraded to provide a key. Please read our Surface Preparation Datasheet.
Selhurst Train Maintenance Depot Crystal Palace; Stewarts Lane Train Maintenance Depot Battersea; Crewe Train Depot, Cheshire; TNA Packaging Birmingham, Nationwide Air Filters; Morecambe, Kraft Foods Wrexham;
You May Also Be Interested In: Strongcoat V for walls.
Strongcoat Technical Data & Colour Chart
Strongcoat Fast Cure & LTC Grade Information